[. . . ] ·:< ·:< ·:<^
AB
Switch on ON/OFF switch. The factory set value H:04 is lit on the digital display.
Start
Rotate programme selector B until the required value is indicated on the digital display. [. . . ] The factory set value H:04 is lit on the digital display.
Start
Rotate programme selector B until the required value is indicated on the digital display. The set value is saved.
Filling the salt dispenser Dissolves limescale (not necessary for set value 0!) . . .
Unscrew cover. Wash immediately.
3 4 6
$
Adding rinse aid
Spick and span . . .
2
Press mark 1, lift up cover 2.
Fill in rinse aid.
Screw on the cover. Attention: Combination products are not suitable for all programmes, follow manufacturer's instructions.
Adding detergent
A lot of dirt, a lot of detergent . . .
5
9000 442 261 (8908) 550 EG
Switching on the appliance
50 ml 25 ml 15 ml
Pour detergent into the dry detergent dispenser only.
Slide cover shut, press. PLOP!
7
Select programme
Quick, economical or intensive . . .
Overview of programmes
The max. The corresponding programmes for your appliance can be found on the fascia.
Start
Intensive 70°
Auto 45°65°
Eco 50°
Gentle 40°
Quick 45°
Prerinse
±²
Duration: hs : mins Energy consumption in kWh Water consumption in litres With Aquasensor
Á
1:30-2:30 0, 55 - 0, 85 6-9
áà é ê
2:40 0, 63 7 1:15 0, 45 7 6
ñð
0:29 0, 45 6 -
ù
ø
The programme data has been measured in the laboratory according to European standard EN 50242. Stains and streaks Rinse aid dosage too high/too low Streaks: reduce dosage. Utensils not dry Rinse aid The combined detergent used has a poor drying performance Appliance setting Milky deposits on the utensils (can be removed) Milky deposits, glasses cloudy/tarnished (cannot be removed) Water softening system incorrectly set No salt Increase dosage. Refill with special salt.
Display "E:25" and "6" are lit Other fault display "E:XX" is lit
Waste water pump blocked
Appliance has technical defect
Call factory customer service (state fault display). Unplug appliance.
Residual water in the appliance
The programme has not yet ended
Close the appliance and switch it on or terminate the programme (see Terminating the programme).
Glasses not dishwasher-proof
Use dishwasher- proof glasses. Use a detergent suitable for glasses.
Rust on the cutlery
Cutlery not rust-resistant Hard knife blades are more susceptible Extraneous rust
Use dishwasher-proof cutlery. Never wash rusting parts in the appliance.
Plastic/utensils discoloured
Too little detergent Discoloration caused by food colourings (tomato sauce)
Follow manufacturer's instructions (detergent). [. . . ] Use a detergent suitable for glasses.
Rust on the cutlery
Cutlery not rust-resistant Hard knife blades are more susceptible Extraneous rust
Use dishwasher-proof cutlery. Never wash rusting parts in the appliance.
Plastic/utensils discoloured
Too little detergent Discoloration caused by food colourings (tomato sauce)
Follow manufacturer's instructions (detergent). [. . . ]